R32 GTR: Overhaul time. Getting started

I'd been slowly collecting parts since obtaining the car with the plans to do a new ECU setup along with supporting mods.

I caught up with Josh for a final drive before pulling the car off the road.

Wings are not only useful for racing, but also eating.
This was actually good timing as it turns out the two year old waterpump had failed and was weeping coolant through the internal seal. This was a Gates unit and I encourage people to go OEM which is what I ended up replacing it with during my overhaul.
I started off removing the AFMs/intake and cleaning up the area underneath.
Gotta give the Chief Inspector some pats while working.
Splitfires and igniter out. So oldschool.
Me being me I got sidetracked and 3d printed some prototype replacement harness retainers in preparation for the new loom.
Anyways, one eternity later I got the OEM loom out. Nissan combined the engine harness with the body harness which was going to make things a bit harder for me as I was going to need to figure out and double check what everything was for.
To add to my annoyance, the wires were glued together under the tape.
It took me ages to be able to separate the wires being careful to not break them in case I still needed them.
The bucket is back. Cutting out and disposing of wires I wouldn't need to use or retain for helping me plan.
Stripped back to the barebones of what I should need. Things will be a lot neater for you if you're not running ABS still.
After a lot of sorting I was able to separate the body loom from the engine loom and recreate a section of it.
Taking a break from that, I created a mount for my ECU to sit under the glovebox for easier routing.
For the ECU itself I decided to go with an Emtron KV8. I've had Haltech in my past few cars and felt like trying something new (to me). It's also a neat package not requiring any extra modules/boxes to suit my intended setup.

Comments

Popular Posts